HELPLINE
01769 575 400

HOW TO START

When cutting ContiBoard it is recommended that you wear safety glasses. As you cut the ContiBoard panel small chips of the surface laminate could be thrown up during the cutting process.


HOW TO CUT

Measuring up accurately is essential. Use a steel measuring tape and sharp pencil or knife to mark your board into panels. 


HOW TO EDGE & TRIM

Use an electric iron to apply the edging. First heat the edge of the board by running the hot iron along its surface, then position the tape along the length. 


HOW TO ASSEMBLE

There is a wide variety of internal fixings available from DIY outlets. The block illustrated is typical and uses three screws to fix two panels at right angles.